When debugging remotely with paths set correctly, the source pane does not update automatically.

When the debugger is waiting to step in/out/over/continue, selecting the *previous* stack frame from the list, and then re-selecting the *current* frame will cause the source for the current file to be loaded.

Can you clarify what you mean by "does not update automatically"? Are you talking about modifications to the file, or is the source pane blank?

Hi,

Apologies - I intended to upload a screen capture showing the issue.. but then I found that *other* bug I reported. I'll add the file now.

Essentially: whenever a new file becomes active, the source pane goes blank, rather than populating with the source. Selecting the previous stack frame, and then the current one, causes it to load correctly.

Cheers

Thanks, I think I have identified the issue. Can you please try the attached build to see if it resolves the issue?

Before unzipping, please run `xattr -c path/to/macgdbp-212.2.zip` because this build is not notarized.